Tag Archives: bricks

Time to get the mortar in – II

Yesterday’s efforts weren’t as effective as I would have hoped.

The blocking and embossing techniques are good at establishing the texture of a stone wall, but so far, all I’ve tried has knocked all the effort back into blandness, only a step up from using embossed plastic card.

So, for the next step, I’ve taken some time over making up a dilute wash of a vaguely cement/mortar type colour. The thing is, you can be too careful. At first the mix was far too dilute, and for me the correct mix seemed to be just past the point when you start thinking, “This must be too thick.” In fact in the end I went even further.

To apply the mortar I arranged surfaces to be treated as close to the horizontal plane as practicable. At first I used an ingenious combination of third-hands and a digital level to set the plane. But let me tell you. Don’t waste your time. If it looks close to, it’ll be okay.

Dropper and Dopper - see what I did there?
Dropper and Dopper – see what I did there?

So, here is the first pass. I used a dropper bottle, available from your recycling bin or local craft store, to dribble my acrylic mortar slurry – in this case, a slightly green tinged beige suggesting moss and algae for this location by a Dartmoor river/stream/leat – and after seeing how it was drying out, dopped off any excess with a stencil sponge. Is “dopped” a word? I think you know what I mean.

Already showing more character, even if it's looking like a new wall although the
Already showing more character, even if it’s looking like a new wall although the “mortar” drops back as it dries

Once that rendering was dry, I dropped a slightly thinner black wash to give a little more relief. Once again, areas which took too much paint were adjusted with the sponge dopper

Close to good... finishing will be done on the layout with other landscape features rendered in
Close to good… finishing will be done on the layout with other landscape features rendered in

The effect is far more evident to the naked eye, and will get a little more apparent upon receiving its final fine matte coat in situ.

So, the next step is the entire Boltorr dam wall itself. I learnt a lot from the smaller bridge abutments, so hopefully I’ll get this done quite quickly.

Before the structure is set in stone, as it were, I want to fix a couple of features, some iron rings, and possibly, where my masonry looks a bit suspect, a couple of ties, all nice and rusty and streaking down the wall.

I also need to get the roof of the brick arches correctly coloured before I forget!

Materials used: foam board, DAS Clay, PVA glue, heat glue, UHU cement, cheap acrylics and paint samples, Woodland Scenics Earth Colors Kit C1215, various cheap brushes and sponges, clay roller.